35
1. Use a sharp X-Acto knife to remove the cov-
ering from the hot air exits.
Note: Use a covering iron to seal the cover-
ing before removing any material.
Electric motor, battery, BEC and ESC installation
2. Final hot air exit holes shown below. It is recom-
mended to go over the edges and seal them
down with a covering iron.
3. Gather the laser cut engine mounting block
pieces (not supplied) 4 6-32 blind nuts, 4 6-32
motor mounting bolts.
Note: Motor mount available from
Aeroworks
4. Use 30 Minute Epoxy to assemble the engine
mounting block.
Hint: Sand the edges of each part and any area
that has been laser cut for a stronger glue
bond.
Commentaires sur ces manuels