AeroWorks Extra 260 Manuel d'utilisateur télécharger pdf (Page 63)

Ignition Installation

1. Gather the ignition and installation parts as

shown below.

IGNITION INSTALLATION

2. Position the engine ignition on the side of the

engine mounting box and mark the location of

the nylon tie holes as shown.

3. Use a 1/8” drill bit to drill the ignition mount-

ing holes.

4. Mount the engine ignition module using nylon

ties and foam rubber as shown. Route the ig-

nition wire to the engine as shown and secure

with nylon ties as necessary. Install the igni-

tion battery and regulator if required as de-

sired. A typical ignition installation is shown

below. Secure all wiring from excess vibra-

tion.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 92 93

Pas de commentaire

AeroWorks Extra 260 Manuel d'utilisateur Page 63