AeroWorks Extra 260 Manuel d'instructions télécharger pdf (Page 14)

14 Aeroworks 30cc Freestyle Extra 260 Assembly Manual

5. Mix epoxy in mixing cup and use a tapered stick

to apply the epoxy inside the pre-drilled holes in

the leading edge of the rudder. Apply epoxy to

trailing edge of each hinge.

6. Carefully slide the rudder onto each hinge and

against the trailing edge of the fin. Wipe away

excess epoxy with alcohol wetted wipes.

RUDDER INSTALLATION

1. Gather the items shown below for the installa-

tion of the Rudder.

Required Parts

◊ 1 - Rudder

◊ 5 - Hinge Points

Required Tools and Adhesives

◊ 30 Minute Epoxy

◊ Epoxy Mixing Cups/Sticks

◊ Petroleum Jelly

◊ Isopropyl Alcohol

◊ Paper Towels

Builders Tip:

Wet paper towels with isopropyl alcohol before

starting rudder installation. This will make cleaning

any excess epoxy easier once the rudder is installed.

3. Mix epoxy in mixing cup and use a tapered stick

to apply the epoxy inside the pre-drilled holes in

the trailing edge of the fin. Apply epoxy to one

side of each hinge and insert the hinge com-

pletely into the hole. Ensure the hinge axis is

vertical and parallel to the trailing edge of the fin

before epoxy cures. Wipe away excess epoxy

with alcohol wetted wipes.

4. Epoxy the hinges into the fin first and allow ep-

oxy to fully cure.

2. Prep all hinges for installation by applying

petroleum jelly or light oil to the hinge joint.

This ensures no epoxy gets into the hinge during

assembly.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 54 55

Pas de commentaire

AeroWorks Extra 260 Manuel d'instructions Page 14