AeroWorks Extra 260 Manuel d'instructions télécharger pdf (Page 26)

26 Aeroworks 30cc Freestyle Extra 260 Assembly Manual

Universal Template:

2. If using a engine that is not a DLE 30 or DLE

35RA please follow these directions for using

the universal template. If a DLE 30 or DLE

35RA is to be used, please skip to step #1 On

page #27

3. Place engine on universal mounting template as

shown. Use a square to align the propeller output

shaft with the pre-marked thrust lines on the

template.

4. Mark the location of the standoffs on the tem-

plate as shown. Ensure that the engine does not

move during this step.

5. Use a stencil to fill in any missed parts where the

standoffs were marked in step 4.

6. Mark the center of each standoff location as

shown.

7. Use a 3/16” drill bit to drill the four mounting

hole locations as shown below.

8. Follow the remaining engine mounting steps for

mounting instructions.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Pas de commentaire

AeroWorks Extra 260 Manuel d'instructions Page 26