AeroWorks Extra 260 Manuel d'instructions télécharger pdf (Page 21)

Aeroworks 30cc Freestyle Extra 260 Assembly Manual 21

36. Adjust the tension of the pull-pull cables until

they are tight. Over tightening cables can bind or

slow servo movement. Adjust cables to allow

some slack as shown.

Note: Due to temperature change and normal wear,

it may be necessary to tighten the cables over

time.

Gather the tail wheel assembly items as

shown below.

Required Parts

◊ 1 - Tail Wheel Assembly

◊ 3 - Tail Wheel Mounting Screws

◊ 1 - Steering Tiller

◊ 2 - Tiller Mounting Screws

◊ 2 - Steering Springs

Required Tools and Adhesives

◊ Phillips Screw Driver

◊ Pliers

◊ Wire Cutters

◊ 1oz Bottle Gap Filling CA Glue

Notice:

Please note optional carbon fiber tail wheel shown,

the 30cc Freestyle Extra 260 QB-L comes with an

aluminum tail wheel. All mounting steps will be

identical, carbon fiber tail wheel available from

Aeroworks.

34. Attach the ball link to the rudder control horn as

shown below. Follow the same steps as shown in

the previous pages to install the ball link to the

pull pull cable.

35. Finished ball link pull pull installation shown

below.

TAIL WHEEL INSTALLATION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 54 55

Pas de commentaire

AeroWorks Extra 260 Manuel d'instructions Page 21