AeroWorks Extra 260 Manuel d'instructions télécharger pdf (Page 44)

44 Aeroworks 30cc Freestyle Extra 260 Assembly Manual

11. Ensure that the front hold down dowels, center

hooks and canopy latch are all engaged. If the

hold down dowels or center hook is not fully

seated the canopy latch will not lock into the

canopy.

Always keep the canopy covered while at the fly-

ing field. Allowing the canopy to sit in direct

sunlight for any period of time may result in the

canopy deck warping, this may make removal of

the canopy difficult.

9. It is highly recommended you apply thin CA

glue to the front hold down dowels. This is a

High vibration area and can loosen the front

dowels.

Always check the front dowels are secure before

each flying session

10. The canopy is secured by a spring loaded latch

as the rear of the canopy hatch assembly. This

latch must be pulled all the way back when in-

stalling and removing the canopy.

1. Gather the items shown below for the installa-

tion of both the inner and outer Side Force

Generators or SFG’s.

Required Parts

◊ 2 - Outer SFG’s

◊ 2 - Inner Top SFG’s

◊ 2 - Inner Bottom SFG’s

◊ 6 - 4-40 SFG Mounting Bolts

◊ 6 - #6 Bonded Washers

Required Tools and Adhesives

◊ 5/64” Ball Driver

◊ .34oz Bottle Blue IC-Loc Thread Locker

INNER AND OUTER SFG

INSTALLATION

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 54 55

Pas de commentaire

AeroWorks Extra 260 Manuel d'instructions Page 44